A place to request Dash features for the Stages development team.
When zeroing both my 4iiii Precision PM's (105 and XT), the L50 comes up with the timeout message, then the successful message.
This happens every single time with my Quarq DZero. Running 2.5.1. Happened on every FW before this as well.
I have noticed the same issue when calibrating the PMs on my StagesBike SB20 via the Stages Link App. Again, it doesn't happen all of the time. Sometimes, I'll just get a calibration number from one PM (i.e. 876, 0), then a second or two later, the zero will change (i.e. 876, 916). Other times it will says 'timeout', then success.
Maybe it is a PM issue rather than a Dash issue?
Every time on both PM's.
Calibrating, Timeout, Successful.
What FW is your Dash on when seeing this issue?
I have the same issue with my Stages Gen3 L/R. It doesn't happen all the time but enough to be annoying. Refer to issue SD2-I-1315.
You won't be notified about changes to this idea.